Manshahia
Resident Fanatic
1.Connect the mobile via USB cable.
2. Open terminal and type su to become root.
3. It will ask for the root password, type in there.
4. Then Issue this command
Phone wud b detected as Modem
5. Then to Edit this file, open it in a Text Editor
Code is
When we issued command in point 4, it showed the address of ur phone that in which USB port it has been connected. note it down from there.
"Modem = /dev/***"
6. When Text Editor opens the file, erase everything from there and Paste the following:
The mOdem has been configured successfully.
To dial the internet conenction type
If eerything goes fine it wud say that connected successfully.
Press Ctrl+C to disconnect.
SOURCE-- Chester
2. Open terminal and type su to become root.
3. It will ask for the root password, type in there.
4. Then Issue this command
Code:
wvdialconf /etc/wvdial.conf
5. Then to Edit this file, open it in a Text Editor
Code is
Code:
kwrite /etc/wvdial.conf
"Modem = /dev/***"
6. When Text Editor opens the file, erase everything from there and Paste the following:
Code:
[Dialer Defaults]
Modem = /dev/ttyUSB0 # <-- Replace it with the reading you got
Phone = *99#
Username = aa
Password = bbc
Baud = 230400
Init1 = ATZ
Init2 = ATQ0 V1 E1 S0=0 &C1 &D2 +FCLASS=0
ISDN = 0
Modem Type = Analog Modem
Carrier Check = No
The mOdem has been configured successfully.
To dial the internet conenction type
Code:
wvdial
Press Ctrl+C to disconnect.
SOURCE-- Chester
Last edited: