can only boot by pressing mem ok!

vishalg

AMD Fanboy
i am able to boot only by pressing the mem ok button (twice) on by asus m5a97 evo board, it gives continuous 1 long and 2 short beeps and the dram led on the board is lit.

i have 2x2 gb corsair ddr3 value rams @1333

1. i have tried clearing cmos by jumper as well as removing the battery.
2. tried booting with single stick of ram
3. cleaning the contacts of ram sticks
4. tried different slots
5. have manually entered the ram timings

but everytime i shutdown my pc for say a few hours, the problem reoccurs:cry:
 

tkin

Back to school!!
Take out the ram, then re insert it, happens to me every time I clean my pc and remove the ram, asus boards are very sensitive to ram connection.
 

d6bmg

BMG ftw!!
1. Power your PC off completely.
2. Take out the RAM modules.
3. Reinsert them.
4. Press Memok button for 5 seconds.
5. Start your PC.
 
OP
vishalg

vishalg

AMD Fanboy
Why don't you revert all the BIOS settings to the original values?
already did that by clearing cmos

Take out the ram, then re insert it, happens to me every time I clean my pc and remove the ram, asus boards are very sensitive to ram connection.
did that several times and also cleaned the contacts

1. Power your PC off completely.
2. Take out the RAM modules.
3. Reinsert them.
4. Press Memok button for 5 seconds.
5. Start your PC.
you mean to say press mem ok before powering on??
 

saswat23

Human Spambot
Keep pressing the memOk button and switch on your PC till your RAM gets detected and system boots. Then restart again and check.
 
OP
vishalg

vishalg

AMD Fanboy
Keep pressing the memOk button and switch on your PC till your RAM gets detected and system boots. Then restart again and check.
did so, but the pc powered on by just pushing the mem ok button.
is this normal?

although it booted up fine after some days again the same promblem occurs :(


Yes!!
MemOK button should never be pressed while the motherboard is powered up.
i used to press it with the pc powered on and booted

can this be due to any grounding issues, coz one of my mobo standoffs(brass) is not properly fitted to the chassis
 

d6bmg

BMG ftw!!
Press memok button in the process I've already mentioned. Your problem will get solved I think.
 
OP
vishalg

vishalg

AMD Fanboy
did the above but the problem remains, each time i boot the system after few hours it beeps with mem ok led on

i have to press memok button each time to boot, this is really getting annoying now :(
 
OP
vishalg

vishalg

AMD Fanboy
no its 1.5v
i am posting the cpuz screens for what the memok has set!!!!!!!!!!!!!!!!
 

Attachments

  • Capture.JPG
    Capture.JPG
    40.8 KB · Views: 147
  • Capture2.JPG
    Capture2.JPG
    47 KB · Views: 139

sumonpathak

knocking on heavens door
try 9-9-9-18 1.5v manually...the timings are not crazy per se...at about 444*2 its supposed to run at that settings....
 
OP
vishalg

vishalg

AMD Fanboy
that didnt help either :(
everytime the system is powered off for few hours it will only boot after pressing memok
its like bios cant remember timing setting
 
Top Bottom