port forward

Status
Not open for further replies.
sanjeed007

sanjeed007

Broken In
how to portforward coz in utorrent sometimes the (/.\) or the red sign comes below.when i try to portforward i set up everythin but i am not able to so the last step coz it is not there in my router settings

my modem-utstar300r2u
connect-BSNL HOME500 PLAN


i setuped the static ip (from 192.168.1.2 to 192.168.1.136)and followed every step but got stuck in the last step of port forwarding
*img517.imageshack.us/img517/2295/untitrk3.jpg
i use utstarr2u as my modem
and here is the screen of the advanced settings .it does not have the virtual server screen at all
*img488.imageshack.us/img488/4982/untitlgn0.jpg
pleas help me
 
shady_inc

shady_inc

Pee into the Wind...
Ahh...My bad!!Didn't have a look at screenies since net was acting funny.:neutral: .

@ sanjeed007: You can try setting up DMZ mode.This will open up all ports for anyone.This can be a security risk if you have got services running on those ports.Or else it's just fine and to easier to set up than port forwarding.
 
OP
sanjeed007

sanjeed007

Broken In
shady_inc said:
Ahh...My bad!!Didn't have a look at screenies since net was acting funny.:neutral: .

@ sanjeed007: You can try setting up DMZ mode.This will open up all ports for anyone.This can be a security risk if you have got services running on those ports.Or else it's just fine and to easier to set up than port forwarding.
Click to expand...
how to set up dmz mode.nothin is runnin on thesse ports i think
 
S

sivarap

In the zone
I have a config like this

Laptop -> wireless router -> BSNL huwaei modem --> internet

I've setup port forwarding in wireless router. now should I setup the same for huwaei modem? does the connection goes out the same port from wireless router? somebody H....E....L....P

sanjeed007 said:
how to portforward coz in utorrent sometimes the (/.\) or the red sign comes below.when i try to portforward i set up everythin but i am not able to so the last step coz it is not there in my router settings

my modem-utstar300r2u
connect-BSNL HOME500 PLAN


i setuped the static ip (from 192.168.1.2 to 192.168.1.136)and followed every step but got stuck in the last step of port forwarding
*img517.imageshack.us/img517/2295/untitrk3.jpg
i use utstarr2u as my modem
and here is the screen of the advanced settings .it does not have the virtual server screen at all
*img488.imageshack.us/img488/4982/untitlgn0.jpg
pleas help me
Click to expand...


Did u check in the advanced tab?
 
Last edited:
[xubz]

[xubz]

"The Cake is a Lie!!"
The Newer UTStarCom Modems have their Telnet Interface Menu (the Shell Works, but the menu is removed) and Port Forwarding Page Removed!

You can apply the firmware from Beetel Modems. Both use the same Processor and Chipset. But I donno if that works correctly.
 
Status
Not open for further replies.
Top Bottom