no display

Discussion in 'Hardware Q&A' started by prabhu.wali, Jul 1, 2009.

Thread Status:
Not open for further replies.
  1. prabhu.wali

    prabhu.wali prabhu.wali

    Joined:
    Oct 4, 2008
    Messages:
    366
    Likes Received:
    2
    Trophy Points:
    0
    Location:
    mysore
    hi,
    i plugged all the connecting cables to clean ma pc hardware
    n after plugging i not able to gwt any display on the screeen n also i restarted after unplugging ram theres no beep but cpu n graphic are workin as normal. please help:sad:
     
  2. surinder

    surinder Tech addict

    Joined:
    Jun 21, 2008
    Messages:
    397
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    In your heart
    Please put in your case in a detailed and proper manner plus do mention your PC's configuration then after someone can try to help you out.
     
  3. pimpom

    pimpom Active Member

    Joined:
    Jul 13, 2004
    Messages:
    1,357
    Likes Received:
    2
    Trophy Points:
    38
    Do you mean that you UNplugged everything?

    Do you mean that you reconnected everything?

    If you're not getting any display, how can you say that your CPU and graphics card are working? Do you mean that the fans are spinning? Spinning fans don't necessarily mean that the devices are working.

    It's very likely that there's something you did not reconnect properly. Carefully check all connections, make sure they all fit firmly. It will be better to pull them out and then re-insert them again firmly. Then try again.

    It will be best to leave the hard disk unconnected until you get a proper display again.
     
  4. Techn0crat

    Techn0crat RPG FTW!!!

    Joined:
    Mar 12, 2009
    Messages:
    156
    Likes Received:
    0
    Trophy Points:
    0
    Your CPU is overheating.
    Make sure you have installed heatsink properly and is in good condition(i.e. no broken screws etc.).Also buy Heatsink paste in a computer store to apply on CPU surface and heatsink bottom.
     
  5. OP
    OP
    prabhu.wali

    prabhu.wali prabhu.wali

    Joined:
    Oct 4, 2008
    Messages:
    366
    Likes Received:
    2
    Trophy Points:
    0
    Location:
    mysore
    i've connected all cables properly n there is no beeping sound after unplugged the ram modules
     
Thread Status:
Not open for further replies.

Share This Page