intake

I wanted to share this personal piece of information regarding my health. For past 3 years I was battling to get my Cholesterol levels below the borderline to an optimal level but had tough time. I tried everything like trying to go to gym daily going on GM diet for one week trying to stay...

Hi all, Need your help again :P I recently bought a desktop and opted for a NZXT Guardian 921RB cabinet. The cabinet has 3 fans. One front bottom (intake), one side panel (intake) and one rear (exhaust) All these are 120 mm fans. There is a provision for a 120 or a 140 mm fan on the top of the...

Used a pair of stockings to make this very effective dust filter for the cabinets(lancool pc k57) side intake fan..... Total cost Rs 50....:-)

My config: CPU : AMD 8320 MOBO : ASUS M5A97 LE R 2.0 GPU : XFX R9 280X RAM : 8GB KINGSTON HYPERX BLU 1600 PSU : SEASONIC ECO 600W CABINET : LANKOOL PC K 57 The cabinet has one intake fan upfront (140mm) and one exhaust fan(120mm) at the back. I have put one additional fan on the side panel, a...

Cabinet Description: Vip cabinet with PSU mounted on top, 2 Fans, 1 is at the rear and acts as exhaust, other is on the side panel (opposite to Processor) which acts as exhaust too. Using the stock Fan for the Processor (i5 3570). I'm not sure whether its drawing the air out or in. Ideally it...

Guys I have a Cm Seidon 120 XL liquid cooler and a HAF 912 cabinet. I had installed the radiator with two fans - one on either side, as exhaust (air being pushed out. I saw in a video for the installation that it should be for intake. Please can somebosy tell me if I should use it for intake...

I am planning for corsair 400r cabinet (not yet purchased & may change) (budget 5-6K max) and will have the Corsair H100 mounted on the top. I keep reading people saying they have it as intake some people as exhaust. What would be the most efficient configuration on this cabinet? will keep...

My cabinet (X-tech) didn't come with one, so i am planning to buy one with my graphic card. I'll be installing it in the rear. Which one do i go for 120mm or 80mm? Should i use it as an exhaust or intake? Budget 300-400 bucks. Phenom II X4 960T Gigabyte M68MT-S2 Corsair 4GB DDR3 Seagate...

in my ELITE 310 REAR FAN is connected to CHASIS 1 FRONT INTAKE is connected to CHASIS 2 Heat sink fan is connected to CPU-FAN Now i want to attach the xtraflo as side intake. How can i connect that. Also it is written that it is a PWM controlled fan? What does that mean?

I have a VIP 400r 400WATTS(atleast it quotes it is) PSU is it sufficient for my current system bcoz i plan to overclock the Graphic card and the Cpu My config Athlon II X4 640 HD 5670(may be i will upgrade to 6750) 2 DDR3 Ram 3x80mm LED(1 rear exhaust and 2 side intake) fans 2x120mm led...

1: i have a Gigabyte M68MT-S2P with Athlon II X4 640 i want to unlock the L3 cache of 640,how do i do it??? 2: i have a Zebronics Bijli Cabinet and i am not happy with the cooling my idle temps are around 30C to 35C and under load it goes over 55C (i have a Hyper TX3 install with AS 5 applied...

i am having CM ELITE 310 cabinet with a rear 120mm fan 1200rpm i want to buy another 120 mm for side intake. 1)should i buy 120mm,1200rpm,39.77 cfm OR 120mm,2000rpm,90 cfm? 2)will two fans of different RPM and CFM cause any disturbance in airflow? 3) can i use them like 2000rpm for...

I tried to install a front intake 120 * 120 * 25 mm fan in my CM Elite 310 (Bought in Feb 2010) after removing the front plastic bezel. However, there is apparently not enough space for the fan to get into the narrow space. I already have a side intake fan (Blademaster 120mm) and a rear exhaust...

Gamma box.... Out of the box, Inside Gamma, Fans to be installed... 1*120mm led, 2*80mm fans from my Bijli, 1*120mm led fan from my bro's bijli.... Components to be installed, Core 2 Quad Q8400, Intel DG43GT, 2*2GB kingston RAM, 1*2GB Nanya RAM, XFX 9800GT 512MB, Asus Xonar DX...

Is a front intake fan effective in a CM Elite310? It has very less mesh for intake towards it's bottom. Elite 310 image by denniszzz on Photobucket

I recently attached a 80mm fan to the side panel of the case (cabinet). Its position is just above the position of my processor in the mobo. Now shud I make it a intake fan or an outgiving (exhaust) fan Sorry 4 the images they r taken by my webcam :cry: :lol: