Ubuntu 9.04 USB bsnl broadband::Geforce 6200

[Rajesh345]

Ubuntu 9.04 :Huawei Quidway WA1003a :USB broadband​

guys , i nd help connecting to net

Router :Huawei Quidway WA1003a

Connection type with PC : USB Cable

i am using usb cable to connect to net in windows , i dont want to add extra pci card 4 eternet (dont have ethernet slot in MB)

note : i searched forum most of the topic says use ethernet port/pci ethernet card ,

*www.indiabroadband.net/linux/10828-how-configure-bsnl-broadband-connection-ubuntu.html


--------------------------------------------------------------

Problem 2 : Geforce 5200,xfx 6200 not supported by ALL linux

my System nvr support linux with display set to graphic card (AGP card)

linux installation freeze after clicking almost Install button (suse,open sus, ubuntu,fedora latest version)

only distro i able to run fine is MINT os

Alternate way i found to install linux is :

a) connect display to onboad graphic (intel 845g onboad graphic )
b) pop up linux cd install it

so : Y linux not accepting my graphic card xfx 6200,geforce 5200 , ati 9250 graphic card , always forced to switch to onboad Graphic`s to USE LINUX < WHICH IS very hard (switching to AGP graphic card 4 windows in bios nd connection cable to card nd switching it to onboad graphic when running Linux
if i tried to run linux in graphic card it freezes


My system config :
P4 2.8
zebronic mobo 845gv
xfx geforce 6200
1.5gb ram
450W power supply

80+160 gb hard disk pata
dvd drive



Thank u

 

[sanderz178]

if it does not work the GUI way i know the terminal commands but first u must get hold of the ethernet cable that comes with that device... i use the same device

type the following commands

sudo pppoeconf

next it will ask the root password
a new colured screen will open and jus follow the instructions they are easy to understand... ur PC will connect
to check type again in the terminal
plog
if it doesn' twork then type
sudo plog

it shows the IP address of u and ur host
this confirms u are connected

 

[sanderz178]

if it does not work the GUI way i know the terminal commands but first u must get hold of the ethernet cable that comes with that device... i use the same device

type the following commands

sudo pppoeconf

next it will ask the root password
a new colured screen will open and jus follow the instructions they are easy to understand... ur PC will connect
to check type again in the terminal
plog
if it doesn' twork then type
sudo plog

it shows the IP address of u and ur host
this confirms u are connected

 

[Ecko]

Congratz 1st dat u have Ubuntu 9.04 cause it rockz
There is a network icon on top hand right side with volume icon (a small PC)
Right click there & click Edit Connection
Create a new connection there in DSL connection after plugging the USB into the NIC port
I expect that you'll be able to create a new connection from there
To dial that connection left click (previously you right clicked) the same networtk icon & select the required connection
Hope this helps
If u face problem then u may reply here