SSD Installation Help

Shibaprasad

Journeyman
hello friends, I just bought Kingston v+200 SSD drive.
1st I disconnected my old seagate 500GB 3GB/s SATA2 HDD from my Mboard's SATA2 port(power also)
2nd I connected my SATA3 6GB/s SSD to Mboard's SATA3 port and also connect power cable
3rd I installed a fresh copy of Win7 64 on SSD
4th I have a sata to usb adapter so I connected my old seagate drive to my laptop and quick formated the C drive in it
5th I installed my old seagate HDD as it was before

Everything works fine but I have a minor problem, both my HDD and SSD are in 'safely remove hardware' notification like pendrive!!!!!
Is everything ok? Did I install everything correctly PLEASE HELP
 
OP
Shibaprasad

Shibaprasad

Journeyman
Problem solved
Disabling Hot plug capability in BIOS solved the problem. Now my SSD and HDD are not shown as removable hardware:razz::razz::razz:
*img189.imageshack.us/img189/6757/imag0247v.jpg
 

Attachments

  • IMAG0247.jpg
    IMAG0247.jpg
    98.4 KB · Views: 91

d6bmg

BMG ftw!!
For any HDD or SSD, Hot-plug should always be disabled and mode should be ACHI.
It should be enabled only for hot-swap bays..
 
Top Bottom