P5B Deluxe WiFi-AP

Status
Not open for further replies.
R

ranjan2001

Cyborg Agent
Sam
I noticed that too but he said in post no.65 of this thread that he has disabled it in BIOS. I do remember that even I had connected it & when facing heat issue 1st thing I was told was to remove the fan as it will interfere with the air cooling....may be its cooling the north bridge heat pipe & that is giving cooler temp but ...............................thats hell lot of a difference in temp of what he is getting & what I am geting. He also is using one for south bridge with a small fan.

I did, though I am not sure what change I saw at that time bcoz I had other issue as well at that time contributing to heat.

@Assasin can u confirm that u are using the Q-fan or not may be you have disabled it in BIOS but if connected then it will be running but wont get speed control.
 
OP
assasin

assasin

Banned
if hav disabled Q-fan in bios.its helps in running the fans at max rpm.
as far as the fan supplied by Asus is concerned its clearly written that u can use it either with with water cooling or even in passive cooling.
installation directions r given for passive cooling though.
and i hav 1 more fan which is installed above the hdd.

@ranjan2001 if u can post ur OC settings,then maybe i cud help.
 
darklord

darklord

Cyborg Agent
Speedstep is something like Cool n Quiet.
Since Assassin mentioned that he had enabled it, means the downclocks the PCU when idle hence vcore is reduced and so is clock speed,maybe that is the reason for such low temps.
 
J

janitha

Wise Old Owl
darklord said:
Speedstep is something like Cool n Quiet.
Since Assassin mentioned that he had enabled it, means the downclocks the PCU when idle hence vcore is reduced and so is clock speed,maybe that is the reason for such low temps.
Click to expand...

But still I can't understand how it can be lower than the ambient temp!
 
R

ranjan2001

Cyborg Agent
assasin said:
@ranjan2001 if u can post ur OC settings,then maybe i cud help.
Click to expand...
I am not running OC anymore but on default BIOS too I have high temp issue.
Right now room ambient is 33C & my cpu is running at 48C & to my default Vcore which was set at auto I have changed it to Vcore 1.13 & after vdrop it runs at v1.10.

@asssin is your Qfan disabled in BIOS but running in actual, please clear the doubt.
 
Last edited:
OP
assasin

assasin

Banned
if u disable Q-fan all ur fans will run @ full speed and will not be controlled by temp of proccy.i've Qfan disabled and its not running anywhere.
 
OP
assasin

assasin

Banned
^^^ i think u sud remove the heat sink,clean it,reapply thermal paste and put it back.this sud make some diff.
 
R

ranjan2001

Cyborg Agent
Assisin that was done twice in my case I further changed psu 500w zebronics, I changed to peace cabinet, yet the problem remained & I have concluded that its the concave IHS which might need lapping.
 
OP
assasin

assasin

Banned
hmmmm....even i once had idle temps of 50 when i first activated dual ch mode.i was pretty scared cuz idle temps had doubled.so i just removed the CMOS batt and oc'ed all over again and guess wat temps were back to where they belonged to (idle 25).
 
deathvirus_me

deathvirus_me

Wise Old Owl
Dual channel increased the temps ??? Hmmm .. this is indeed an oddity :p ...

But even then , 25c idle , on air with stock cooler is indeed good enough ...
 
R

ranjan2001

Cyborg Agent
deathvirus_me said:
But even then , 25c idle , on air with stock cooler is indeed good enough ...
Click to expand...
Thats an anvious ideal temp & impossible to achieve even with best of the coolers in the market........specially when the ambient temp is 35C & above.

Lol...........I am seriously thnking of shifting to Durgapur:D:D:D
 
T

TEÂM ĎIGIT IS IMP0ST0R

Banned

HEHHEHHEHEEHE :)) :))

ALL THESE DUMB A$$ES ABOVE AND BELOW THIS POST ARE DUPLICATE IDS OF FUC*KING TEAM DIGIT :p :p :p

_________________________________

THIS TOPIC IS SPAM AND SPAMMED BY F*UCKING TEAM DIGIT :p :p :p

FU*CKING TEAM DIGIT IS IMPOST0R :p :p :p
 
OP
assasin

assasin

Banned
hey can i run a SLI setup on my P5B DLX which supports cross fire?
afaik SLI or crossfire dont give much of a performance boost.is it true?
is it worth it to run 2 DX10 gpus?
 
R

ranjan2001

Cyborg Agent
to my knowledge they are different technology.
Read these links
*www.atomicmpc.com.au/article.asp?SCID=15&CIID=24212
*www.cdrinfo.com/Sections/Reviews/Specific.aspx?ArticleId=14474

If that was possible then ATI cards could have been used on SLI & vise versa & no need to develop crossfire at all.
 
Status
Not open for further replies.
Top Bottom