i done on it all file convert in .ko extantion
in readme they told me to edit modules.conf or conf.modules
i edit and add this line
alias sound-slot-0 cmaudio
post-install sound-slot-0 /bin/aumix-minimal -f /etc/.aumixrc -L >/dev/null 2>&1 || :
pre-remove sound-slot-0 /bin/aumix-minimal -f /etc/.aumixrc -S >/dev/null 2>&1 || :
but there is no change in sound dirver
i m using fedora 6
here is the readme file can some one explane me how to install in
Linux OSS driver for C-Media audio codec (CMI9738, CMI9739, CMI9761)
Notes:
1. This version implements GPIO on/off when active/disactive the driver which used for Mitac.
Features:
1. South Bridge: Intel ICH2/ICH4/ICH5, SiS 7012/7018, VIA 8233/82686, ALI 5451, nVidia nForce, AMD 8111.
2. Full-duplex and multiple applications playback and recording.
4. 16 bits 2/4/6 channels mono/stereo playback.
5. 16 bits stereo recording.
6. Support phone jacks configuration.
7. PCM SPDIF IN/OUT (CMI9739 and CMI9761, recording only support 48 KHz).
8. Support AC3 S/PDIF out (CMI9739 and CMI9761).
9. Support analog hardware copy to rear channel.
10.Support xear mode to swap front and surround speakers output.
For PCCHIPS LCD PC, you should change the following codes in cmaudio.h:
// For PCCHIPS LCD PC
#define FORCE_LINEINASREAR_MODE 1
#define FORCE_XEAR_MODE 1
//#define FORCE_LINEINASREAR_MODE 0
//#define FORCE_XEAR_MODE 0
Known issues:
1. This driver only tested on RedHat 7.3.
2. /dev/sequencer is not supported.
3. In RedHat 8.0, gmix can not select recording source correctly.
Please use aumix.
Installation:
For driver installation, please follow below steps.
Step 1. Unzip source code
tar xzf cmaudio-xxx.tar.gz
Step 2. Complied source code and install
./install
Step 3. Edit your /etc/modules.conf or conf.modules depending on the Distribution
alias sound-slot-0 cmaudio
post-install sound-slot-0 /bin/aumix-minimal -f /etc/.aumixrc -L >/dev/null 2>&1 || :
pre-remove sound-slot-0 /bin/aumix-minimal -f /etc/.aumixrc -S >/dev/null 2>&1 || :
Phone Jacks Configuration:
We provide a console mode program, cmconfig.c, in order to let you change jacks' configuration.
please follow below steps.
Step 1. Compiled source code, the source code is also in cmaudio-xxx.tar.gz.
cc -o cmconfig cmconfig.c
Step 2. Execute and change the settings
./cmconfig
