plz help me

[bigdaddy486]

I had accidently changed my ram's frequency into 667mhz while it is 533 mhz actually. now, there is no display and when i turn on the cpu, there are 3 beeps andthen nothing happens. what should i do? i need in immideate answer before my father find this because i am only 13....

 

[slugger]

i need in immideate answer before my father find this because i am only 13....

LOL!!!

ok take out d battery form d mobo and keep d mobo i dat stat 4 around 2-5 mins
if ur mobo needs u 2 take out d jumper 2 reset d BIOs den do dat

but i think d battery is enuf

gud luk
hope dis is enuf 2 save u from gettin spanked by ur DAD

 

[bigdaddy486]

plz tell me what is a juumper and where is it situated?

 

[Pathik]

next to the cmos battery u ll remove.. Refer to ur mobo manual

 

[bigdaddy486]

i saw a thing, blackshaped . is it? how can i take it?

 

[dOm1naTOr]

The battery is like a round metal coloured plate like thin cell. Theres a lock at its edge. take out anr replace after 60 sec and ur bios has been reset.

see da image

*img253.imageshack.us/img253/7910/a8nebe5.jpg

 

[bigdaddy486]

i have waited for about 15 minutes by taking out battery and jammer but no use.......
i may leave this site soon and will get a beat from my father....

i have waited for about 15 minutes by taking out battery and jammer but no use.......
i may leave this site soon and will get a beat from my father....

 

[slugger]

i have waited for about 15 minutes by taking out battery and jammer but no use.......
i may leave this site soon and will get a beat from my father....

did u put d battery and jumper back in

and r u sure u took out d correct jumper

PLEASE refer your motherboard's manual to see exactly which jumper is ment for resetting the BIOS,
the motherboard has lots of jumpers in it for doind many things

u must takeout d correct jumper

 

[bigdaddy486]

anyway, after your all advice and my hardwork for 4 hours, i rescued myself from my father and my cpu also.....
what i have to do is take out the jumper and battery as mentioned and also, i have to place my cpu vertically and put on the jumper and battery

Oh, now its another problem -it shows that it didn't find any harddisks.....

 

[slugger]

i have to place my cpu vertically and put on the jumper and battery

Oh, now its another problem -it shows that it didn't find any harddisks.....

LOL!!!!

u obviously have 2 put d jumper and battery back into 2 mobo after takin it out

as 4 d second problem [HDD] just push d data and power cables back firmly in2 d sockets

remember, firmly but carefully

 

[dOm1naTOr]

yup, it might be some loose connection. Recheck the data cable nd power connector of the HDD.

 

[bigdaddy486]

thats not the problem, i have changed its configuration into raid and when i changed it inti ida, it worked but i couldnot use intergreated graphics becaise whenever i install the driver and reboot, there is no display. also, plz tell me how to configure my sata harddrive into raid and what is its use?