PC shuts down all of a sudden and needs to power on to boot into windows... Please help...

bssunilreddy

Chosen of the Omnissiah
Hai,

PC shuts down all of a sudden and needs to power on to boot into windows... My config is in my Signature.Is it the Mobo or the PSU? My Mobo is Gigabyte B85M-D3H Rev1.0 & PSU is Corsair VS550.Do I need to change the PSU as I was thinking to buy Seasonic S12II 520w in March.
I re-assembled my whole PC 2 times but I could not rectify this.
Please help...


Thanks,
BSSunil
 
Last edited:

RBX

In the zone
It could be overheating. See if heat sink/fan are properly placed, and use a temperature monitoring utility.
 
OP
bssunilreddy

bssunilreddy

Chosen of the Omnissiah
It could be overheating. See if heat sink/fan are properly placed, and use a temperature monitoring utility.

This shutdown happens even when I am browsing internet or doing very simple tasks and not like gaming.It did not happen even one time during gaming.

Any other suggestions please...
 
Last edited:

HE-MAN

Ambassador of Buzz
first go into bios and do a default settings save and exit.... and then try just keep ur pc on and see it happens again.
 

Alok

Adventurer
1. Check your OC settings...if OCing then don't. Test it.
2. Reset BIOS. Test again.
3. Get your friend's PSU, replace your PSU with It and check if problem still persist.
 
OP
bssunilreddy

bssunilreddy

Chosen of the Omnissiah
I bought a CX430 PSU + CM Hyper TX3 EVO Cooler but my temps are still very high. The assembler who have done the assembling did not put the cooler in its usual position but take a look here for the temps & Cabby foto:

*i.imgur.com/Npr2eUA.png

*i.imgur.com/LpL1dmJl.jpg
 
Last edited:
OP
bssunilreddy

bssunilreddy

Chosen of the Omnissiah
its high without any load :-(
try changing thermal paste.

I found out the problem. CM Hyper TX3 Evo 4 legs did not properly seat on the processor itself as 2 of the 4 legs broke of because of a stupid ******* ASSEMBLER who took Rs.500 for assembling my PC.

Can I get TX3 Evo RMA'ed as it is only 5 days old.Will I get a new one.

Now see the temps even with the Intel Stock cooler itself:

*i.imgur.com/zvK0ikQ.png
 

Alok

Adventurer
Good it had doubt about heatsink/thermal paste. Ask the customer support, I think they won't provide new as its damaged due to poor handling.
 
OP
bssunilreddy

bssunilreddy

Chosen of the Omnissiah
Good it had doubt about heatsink/thermal paste. Ask the customer support, I think they won't provide new as its damaged due to poor handling.

I asked the Cooler Master Service Center walla. He said I should return it to the seller so that the seller will RMA the product himself.
 

Desmond

Destroy Erase Improve
Staff member
Admin
I bought a CX430 PSU + CM Hyper TX3 EVO Cooler but my temps are still very high. The assembler who have done the assembling did not put the cooler in its usual position but take a look here for the temps & Cabby foto:

*i.imgur.com/Npr2eUA.png

*i.imgur.com/LpL1dmJl.jpg

Mother of cable-management!

On topic:

90+ degrees on casual usage? Wow, you are killing your CPU. Change your TIM and make sure your heatsink is attached firmly. Do this first and then check if the problem gets resolved.

- - - Updated - - -

For a better calibration of temperature, use RealTemp or HWMonitor. I don't trust other utilities to be accurate.
 
OP
bssunilreddy

bssunilreddy

Chosen of the Omnissiah
Mother of cable-management!

On topic:

90+ degrees on casual usage? Wow, you are killing your CPU. Change your TIM and make sure your heatsink is attached firmly. Do this first and then check if the problem gets resolved.

- - - Updated - - -

For a better calibration of temperature, use RealTemp or HWMonitor. I don't trust other utilities to be accurate.

Take a look at the cable management now
*i.imgur.com/CNDXcZp.jpg

Take a look at the temps
*i.imgur.com/59Yp0H5.png

*i.imgur.com/JXP90Nf.png
 

bikramjitkar

In the zone
Hyper TX3 Evo is a bit tricky to install. Make sure you remove your motherboard from the case before installing. I did it with the mobo in the case and it was a rather painful process, even though I have a large case.
 
Top Bottom