This tutorial is to convert simple bitmaps to fully editable vector art in 5 easy steps.
It Can be used with Flash 3 and later versions.
In response to Vicky's art here >> *www.thinkdigit.com/forum/viewtopic.php?t=19863
Sample Art
*img132.echo.cx/img132/729/asoka28uu.jpg
*img132.echo.cx/img132/2416/rani72sb.jpg
1. Open a new file in flash. ( File>>New)
2. Import the picture file (File>>Import )
3. Goto Modify menu and choose Trace Bitmap.
4. Use the Trace Bitmap dialog box to adjust the settings when converting your bitmap to a vector.
Normal Settings:-
-----------------------
Color Threshold = 100
Minimum Area = 8 Pixels.
Curve Fit = Normal
Corner = Normal
-----------------------
The setting in the threshold field can be changed from 0 to 500.
Minimum Area setting determines the pixel size of the shapes created by each tracing, and the Curve Fit determines how Flash approximates the curves in the image. If you choose Very Smooth, for example, Flash draws long smooth lines in the curved areas of the image. Leave the settings at their defaults (if your image doesn't look right, you can choose Undo and change them)
After you apply the trace bitmap command, press escape to deselect the image.
You can now save or export the file through, File>>Export.
The same thing can be done manually by edge tracing but its a very hard procedure.
Manually ,it goes through these steps :-
*img181.echo.cx/img181/5784/stages3cx.gif
It Can be used with Flash 3 and later versions.
In response to Vicky's art here >> *www.thinkdigit.com/forum/viewtopic.php?t=19863
Sample Art
*img132.echo.cx/img132/729/asoka28uu.jpg
*img132.echo.cx/img132/2416/rani72sb.jpg
1. Open a new file in flash. ( File>>New)
2. Import the picture file (File>>Import )
3. Goto Modify menu and choose Trace Bitmap.
4. Use the Trace Bitmap dialog box to adjust the settings when converting your bitmap to a vector.
Normal Settings:-
-----------------------
Color Threshold = 100
Minimum Area = 8 Pixels.
Curve Fit = Normal
Corner = Normal
-----------------------
The setting in the threshold field can be changed from 0 to 500.
Minimum Area setting determines the pixel size of the shapes created by each tracing, and the Curve Fit determines how Flash approximates the curves in the image. If you choose Very Smooth, for example, Flash draws long smooth lines in the curved areas of the image. Leave the settings at their defaults (if your image doesn't look right, you can choose Undo and change them)
After you apply the trace bitmap command, press escape to deselect the image.
You can now save or export the file through, File>>Export.
The same thing can be done manually by edge tracing but its a very hard procedure.
Manually ,it goes through these steps :-
*img181.echo.cx/img181/5784/stages3cx.gif
