Abit IP35-E install query

Status
Not open for further replies.
Ranjya

Ranjya

Broken In
Everybody was recommending this mobo.
It is nice .........except for double boot.(BIOS 15)

Problem 1
For Power LED it has 1-0-1 pin
My cabinet has 1-1-0 pin for Power LED.
It does not work. Solution ??

Problem 2 ??
CPU temp 45C
System temp 39C
Are these OK or Normal ( No OC done ) Speedfan readings,
BIOS gives higher temps.

Problem 3
I have a iBall WindowsX cabinet.
This has a funnel on side panel above CPU HSF.
Can I install a fan here? exhaust or intake ?
My chassis fan (exhaust) has a molex power pin,
so it is naturally not being controlled, being powered by
PSU directly. Any solution ? Maybe I can change it?
Suggest good fans......where to buy.

SORRY for a longish post.
 
OP
Ranjya

Ranjya

Broken In
hellgate said:
cud u post pics of ur cabby pwr led connector.

I will post later.

wat procy do u hav?mobo temps r ok
Click to expand...

Procy is E2180

BIOS temp
CPU temp 51C
Sys Temp 35C
PWM temp 43C
CPU Fan 2481rpm

I boot and Speedfan reading
Sys temp 36C
CPU 42C
AUX 47C
Temp1 50C*
Core0 39C
Core1 42C
Core 60C*
CPU Fan0 1223rpm*
These * are the worry, also the BIOS discrepancy in temp.
regards
 
N

nish_higher

Wise Old Owl
sometimes these programs give a wrong reading too.. i've found bios temp to be much more accurate..
try using coretemp or rrealtemp

still temps are ok..
 
OP
Ranjya

Ranjya

Broken In
nish_higher said:
still temps are ok..
Click to expand...

What would be good temps for E2180 with stock cooler ?
That is the question I want answered ;-)

hellgate said:
disable the abit EQ fan control in Bios.ur cpu fan will run at full speed.
Click to expand...

I hear this increases the sound from fan.
Intel says fan goes to full speed only after CPU temp to 75C.

*www.intel.com/support/motherboards/desktop/sb/CS-012552.htm

I went through this article very briefly ;-)
 
Last edited:
N

nish_higher

Wise Old Owl
normal temps are 45-60
and the side fan should blow air inside the cabinet.u should put a fan there
no need to run proccy fan at 100% unless u overclock
 
Status
Not open for further replies.
Top Bottom