varunprabhakar
In the zone
i am having ddr400 ram 512mb. but in bemchmarks its showing 200mhz??
wher lies d problem??
wher lies d problem??
- Status
Arsenal_Gunners
Human Spambot
mine shows 335 mhz.512*2 ddr 400 on nforce 4 ultra.
I used ntune to benchmark my memory.the results were much below the baseline
scores.what can cause that.my disk and graphics(geforce 6600) performance results were much higher than the baseline.
I used ntune to benchmark my memory.the results were much below the baseline
scores.what can cause that.my disk and graphics(geforce 6600) performance results were much higher than the baseline.
OP
varunprabhakar
In the zone
yes it is ddr 400
OP
varunprabhakar
In the zone
mine is also nforce. is it related to clock speed?? bcoz in m/b settings, clock speed shows 200mhz..
OP
varunprabhakar
In the zone
but isnt it supposed to work at 400mhz??
Arsenal_Gunners
Human Spambot
what about my test results 
wizrulz
GUNNING DOWN TEAMS
varunprabhakar said:
see in one clock cyle there is one rising edge and a falling edge.......
It achieves greater bandwidth than the preceding single-data-rate SDRAM by transferring data on both the rising and falling edges of the clock signal (double pumped). This effectively nearly doubles the transfer rate without increasing the frequency of the front side bus. Thus a 100 MHz DDR system has an effective clock rate of 200 MHz when compared to equivalent SDR SDRAM, the “SDR” being a retrospective designation.
nishant_nms
Cyborg Agent
It is working at 400 MHz no need to take tension
OP
varunprabhakar
In the zone
my fsb is set to 200 mhz.
OP
varunprabhakar
In the zone
does tht mean tht ddr2 533mhz will show speed of 266mhz
- Status