Problem!! No Display

Bhushan007

Right off the assembly line
Hello friends!!

My system config is :
XFX 630i 7100 MB.
C2D 8400 3GHz Processor
4gb 800MHz Kingston RAM
500watts Vip SMPS
WD 500GB HDD
XFX 8600GT 512MB DDR2 Graphics card

Recently my system crashed and now the monitor does not display any thing..
I connected my monitor to other system and it is working fine..
my graphics card is also working fine...
I tried connecting the monitor on the Mobo's VGA port, removing the graphics card but still there is no display...
:shock:
I dont know what to do..:?::?:
plz help...
 

Gollum

Collector
when you try to boot the PC, does the HDD light show any activity (does it keep on blinking continuously?)
do you hear any beep codes.
have you tried swapping the ram module?
 
OP
B

Bhushan007

Right off the assembly line
I have tried swapping the RAM modules...
The hard disk light does not blink continously.. I think the HDD is fine...
While there a no beeps at all...:-(
 

casual_gamer

In the zone
i had exactly the same problem and it was due to motherboard. the repairman could not repair it and killed it completely, now it won't even turn on. it was a 10 year old 815 board, finally i got a reason to buy a new system.

what motherboard do you have?
 

dude_gamer

Half Life2-Follow Freeman
(may be capacitor of your motherboard dead)
Same thing happened with me last year & my hardware engineer replace defective capacitor of my motherboard that's all.everything works fine.
 
Top Bottom