eth0

  1. X-jo

    ethernet connection dropping on Linux Mint

    :dmesg [83903.387634] atl1c 0000:01:00.0: irq 43 for MSI/MSI-X [83903.387739] atl1c 0000:01:00.0: atl1c: eth0 NIC Link is Up<10 Mbps Half Duplex> [84964.096716] atl1c 0000:01:00.0: atl1c: eth0 NIC Link is Down [84966.229340] atl1c 0000:01:00.0: atl1c: eth0 NIC Link is Up<10 Mbps Half Duplex>...
  2. esumitkumar

    how to setup BSNL Broadband in Ubuntu 8.10 ??

    HI How to do this ? When I connected cable to laptop it detected automatically as auto eth0 But it doesnt open any website like yahoo etc ..plz help
  3. abhinandh

    The Archlinux thread

    i successfully installed arch linux but am unable to configure the network. my realtek ethernet controller uses r8169 module.module loads but card is not detected. under ubuntu, dmesg | grep r8169 gives[ 24.262045] r8169 Gigabit Ethernet driver 2.2LK loaded [ 32.373381] r8169: eth0: link...
  4. mayanks_098

    wth is d prob with my bsnl home 500?

    hey all. was thinking of asking this for long but cudnt coz of 2 reasons. 1.i m busy vaccationing 2. its what d prob is,my connection has gone nuts. so the prob is that my connection is behaving extremely annoyingly. it just doesnt starts.when i start my router sometimes d 4 led's blink...
  5. praka123

    Dataone Adsl in Debian Sarge 3.1..help

    :D Hello i use Sarge 3.1 with Dataone using pppoe and configure with 'pppoeconf'.only problem is i need to brought up lan eth0 maually by running debian:/home/prakash# ifconfig eth0 up debian:/home/prakash# pon dsl-provider Plugin rp-pppoe.so loaded. here is my /etc/network/interfaces...
Top Bottom