Recent content by max_snyper

Hi guys, how much can i fetch for the given below config. Intel i3 6100 Asrock 110hdv Corsair TX850w Corsair 400r carbide series (3 stockfans and 2 bit fenix 140mm) Corsair H100 series CLK NZXT fan controller 5 channel

Hey, Sorry for replying late, tried everything as suggested, found out the culprit to be failing secondary hard drive (tried to check if motherboards ports are bad but they were ok) , the system only crashes when this drive is connected to the system. Now the issue is how do i retrieve...

Hi guys , this is happening a lot since last week Specfication processor : Intel I3 6100,asrock h110dv, 8gb ram, 1050ti gpu, 850w corsair tx series, 512 gb ssd,512 hdd. This has been going on since last week, whenever the pc boots up after few minutes it freezes up and restarts with not post...

Returned the motherboard back to Amazon...now waiting for them to return the amount .....how much time do they take to return the money...?

Checked jumper setting, checked for any loose connection Even checked gskill website....turns out the board is on qvl list of my ram ....I have 2 sticks of ram so tried one by one too....processor it also supported...still no luck.

Hi Guyz ....bought Intel dh77eb from Amazon. Ran into new issue.....the board doesn't boot....it keeps restarting, there is a standby led on the board which blinks for 2 times and the system restarts.. same process again stuck in boot loop.....! Is the board doa or m I doing something...

Hey Guyz, Went to see if my board could be repaired..power chips were fried ....could not be repaired.....any board available for Intel 2500k in market...not in mood to upgrade the whole setup atleast for an year....need suggestion guys.

The system is 4 ye old....and tried that one too with screw driver...all the fans spin just for a split second...and shuts down....on the motherboard just as I switch on the mains....there are two set of buttons on the motherboard....on button and reset button....reset button led powers down...

Tried everything.used eraser on contacts...replugged all connections...ran just with bare bone components...still nothing..Here is my PC specs....

Hi guys, My PC is failing at post, when I try to switch on the PC, the fans of the PC move for half a second and then nothing happens. Dismantled all the components and running just the core components ,still no luck. Tried the paper clip test on the psu works fine, all the cabinet fans and...

If India is a computer.......then i hope it gets self aware as skynet & squashes all the not required elements that hampers the progress of our country...!

thankx guyz.....All your suggestions will definitely help me in the current scenario as well as in the near future...!

What happens if i dont get releasing papers....is that thing of a concern for next job as it has been only 3 months.....and then too this job exp. would'nt be applicable for any dev profile.

hey guyz......thanks for the suggestions....have been busy lately.....! I submitted the resignation through e-mail to the competent authorities a week ago & willfully accepted to work for the following week (w/o pay)....so that my replacement can be found (mentioned this in my resignation...

Thank you guyz for all the opinions....... If i work as a tech support job for atleast a year .....in the mean time i sharpen my skill on .net....would'nt that help me in dev. job hunt, even as a fresher(for dev profile) or exp(in application support)....? Or i have to compulsory leave my...