USB's not working after bios updating

Discussion in 'Hardware Q&A' started by shikhar_kapoor143, May 11, 2006.

Thread Status:
Not open for further replies.
  1. shikhar_kapoor143

    shikhar_kapoor143 New Member

    Joined:
    Oct 21, 2004
    Messages:
    63
    Likes Received:
    0
    Trophy Points:
    0
    hello der everyone i have D845GVSR i just updated my motherboard with the software available on the intel site after installing it ,it showed successful installation but when i enter into the bios setup nd check USB config there is nothing nd USB is not working plz is there nyway i can rectify this problem
    plz help me its urgent
     
  2. samrulez

    samrulez New Member

    Joined:
    Apr 16, 2006
    Messages:
    1,334
    Likes Received:
    4
    Trophy Points:
    0
    Was the BIOS update for u r BIOS?Try restoring it to the sefault version.
     
  3. OP
    OP
    shikhar_kapoor143

    shikhar_kapoor143 New Member

    Joined:
    Oct 21, 2004
    Messages:
    63
    Likes Received:
    0
    Trophy Points:
    0
    man ut was for my motherboard only and how can i restore it to the default version after updating???
     
  4. Sourabh

    Sourabh Laptoping

    Joined:
    Aug 15, 2004
    Messages:
    2,206
    Likes Received:
    8
    Trophy Points:
    38
    Location:
    Mumbai
    This is a common problem with 845 boards. All you have to do is get into the bios and reset to default settings. If you check out the help file, you will get the same recommendation.
     
  5. OP
    OP
    shikhar_kapoor143

    shikhar_kapoor143 New Member

    Joined:
    Oct 21, 2004
    Messages:
    63
    Likes Received:
    0
    Trophy Points:
    0
    can u tell me how i can reset it to default settings
     
  6. Sourabh

    Sourabh Laptoping

    Joined:
    Aug 15, 2004
    Messages:
    2,206
    Likes Received:
    8
    Trophy Points:
    38
    Location:
    Mumbai
    dude just get into the bios by pressing the del or F2 key whichever is applicable, and you will find that option in the BIOS. Save changes and restart. It doesnt get any simpler than this.
     
  7. OP
    OP
    shikhar_kapoor143

    shikhar_kapoor143 New Member

    Joined:
    Oct 21, 2004
    Messages:
    63
    Likes Received:
    0
    Trophy Points:
    0
    man i just did it by getting the jumper off to configure mode nd then resetting the motherboard as the usb was not enabled thnx for ur help man
     
  8. Sourabh

    Sourabh Laptoping

    Joined:
    Aug 15, 2004
    Messages:
    2,206
    Likes Received:
    8
    Trophy Points:
    38
    Location:
    Mumbai
    So did you reset the bios to default settings ? If you did so, things should work out.
     
Thread Status:
Not open for further replies.

Share This Page