unable 2 write DVDs

Status
Not open for further replies.

slugger

Banned
I recently bought a LiteON LH-16AIP Super All Write DVD writer. I was able to burn Cds without problem. however when I try to burn DVDs I get the following error message.

*img242.imageshack.us/img242/208/writeryi6.gif

Using NERO 7 essential for burning.
My config
AMD Athlon XP 2100+
2*40 GB HDD
2*256 MB RAM
I also tried disabling the overburn feature and disk at-once feature but still could not burn a DVD

Please tell me whats going wrong and how to go about doing it properly
thanx
 

wizrulz

GUNNING DOWN TEAMS
first try udating ur firm ware...else
Enable ur DMA
if not this
change ur ASPI

run the "killASPI" batch file, rebooted, then ran the "instASPI" and rebooted again.more info *www.nu2.nu/aspi/...else google for killASPI and instASPI
 

suman2005

Broken In
I read somewhere that these newer Liteon DVD writers insisit on a 80 wire ATA100 data cable. Check if you are using this type of cable and not the older 40 wire ATA33 cable.
 

Vishal Gupta

Microsoft MVP
I faced similar problem in my Sony DW-G120A DVD writer when I tried to burn MoserBaer DVDs :(
But it was problem in firmware, after upgrading the firmware the problem was solved :)
 
OP
slugger

slugger

Banned
using sony media and also using 80 wire IDE cable DMA enabled (through BIOS)
will update firmware and see
 

premsharma

In the zone
slugger said:
using sony media and also using 80 wire IDE cable DMA enabled (through BIOS)
will update firmware and see

Fixation error is due to media compatibility. It may be solved through firmware update. Light On is supposed to take wider range of media including locals. Trying changing your media, try out any local media for once or Writex, Eurovision etc. You would come to know that where the problem lies.

Upgarding firmware, will add support for more media & burn speeds etc. Want anything of firmware or product reviews, look at cdfreaks.com
 
Status
Not open for further replies.
Top Bottom