TV Tuner Card REMOTE Problem..Urgent help required

[achtung]

Hi,

I have got one frontech internal TV tuner card.
I connected it to PCI 2, and installed the driver and the application(TV Plus) to operate it.

Problem is, when I am trying to use the remote control (e.g. power button, channel shift), remote is not working at all.

Also can anyone distinguish between the composite mode and cable mode?

also after connecting the cable line, most of the channels are flickering.

Please suggest..
Thanks..

 

[achtung]

Still the Remote is not working...
Tv Tuner model number is Frontech internal JIL 0606
ANY One!!!!! ?????
Plz H..e..l..p

 

[prasad_den]

Errr.. something very basic.. Have you checked whether the batteries in the remote need replacement..?

 

[achtung]

Actually I haven't checked that because it is a new one supplied with the tv tuner card itself.
I'll check that and let u know then...
Thnx for the hint

 

[vikasg03]

If still it is not working then i know the reason. It needed a remote patch. I am also using the same model tv tuner. After installing the remote patch (size only few KB ) , it start working.
If u need that i will send to u
Vikas

 

[aswin1]

Hope you have connected the TV remote sensor unit to the proper slot and put it in the front of the PC.

 

[royal]

Hope you have connected the TV remote sensor unit to the proper slot and put it in the front of the PC.

I was also going to suggest that

or else @vikasg03 can help

 

[achtung]

Unfortunately I have tried all these... but noo good guys

I think only the patch can help me out...
VIKAS.. could you please provide me the patch ?????
Many thanks in advance ...

P.S. my mail id: uttiya.t2008@googlemail.com

 

[vikasg03]

chk ur mail. hope it works

 

[patkim]

also after connecting the cable line, most of the channels are flickering.

While H/W or S/W failure can not be ruled out, the flicker could simply be due to need of fine tuning. Do check the application and look for fine tuning settings.

 

[achtung]

Hi Vikas,

I had gone through the read me and followed the steps.
1. First ran the unremote.exe
2. then re booted the PC
3. then ran remotemap.exe


But the remote didn't respond. I used two new batteries, just in case.
Any other method of applying the patch??

Please suggest.

Regards

 

[samirshah8]

Unfortunately I have tried all these... but noo good guys

I think only the patch can help me out...
VIKAS.. could you please provide me the patch ?????
Many thanks in advance ...

P.S. my mail id: uttiya.t2008@googlemail.com

Please send me that patch I need to work remote well for Frontech TV Tunner card.

P.S. my mail id: samirshah8@gmail.com

 

[paroh]

can u tell what the program actually do unremote.exe and remotemap.exe??

 

[vikasg03]

Check your mail, But gmail don't allowed exe, so i am sending you in zipped format.. just remove extra words from extension (ped)
vikas