STOP MESSAGE CODE

Discussion in 'QnA (read only)' started by NitroNits, Apr 16, 2006.

Thread Status:
Not open for further replies.
  1. NitroNits

    NitroNits New Member

    Joined:
    Jan 12, 2006
    Messages:
    18
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Chandigarh
    Sometimes while working on Win XP, the PC hangs and the blue screen appears with the following error message:

    "Kernel_data_inpage_error

    STOP: 0x0000007A (0xE1524454, 0xC0000C0E, 0xBF9053BC, 0x1809A860)

    Win32k.sys_address BF9053BC base at BF800000, Datestamp 3b7de698

    Beginning dump of physical memory."

    I searched on d net about this problem but couldnt find a solution. Please help me out with this. My PC config is 512 MB RAM, 40 GB HDD, 2.5 Ghz, P 4.

    Thanks,

    Nitish
     
  2. sakumar79

    sakumar79 Active Member

    Joined:
    Nov 28, 2004
    Messages:
    2,445
    Likes Received:
    9
    Trophy Points:
    38
    Location:
    Madurai
    The following are all common causes of STOP Messages 0x00000077 and 0x0000007A:

    1. The paging file contained a bad block.
    2. If the page file is on a SCSI device, the trap could have been caused by improper termination.
    3. Bad cabling from hard disk to controller.
    4. An error on the disk controller.
    5. Running out of non-paged pool resources on the server.

    If the Stop message mentions the file Win32k.sys, the source of the error might be a third-party "remote control" program. If such software is installed, you might be able to disable it by starting the system in safe mode. If not, use Recovery Console to manually delete the system service file that is causing the problem. However, this was info provided for stop 0x0000001E error...

    Arun
     
Thread Status:
Not open for further replies.

Share This Page