Printer Catridge Not Detected After Refill

[thewisecrab]

Hi Guyz
I hav an HP F380 printer/scanner
I used to refill the introductory catridges once XP said It was low on ink
and then i would continue using it again
Now After refilling it the third time, The Printer And HP suite refuses to detect the catridges (saying there is a fault in alignment)
If i remove the black catridge it detcts the tricolor one and says to insert the balck one
but when i insert them both , it says that both have a flawed alignment
have these catridges gone??
Shud i buy a new HP catridge??
Or am i doing sumthing wrong????

 

[Gigacore]

Its common prob.. even i was able to use the refill cartidge for 3 - 5 Times..

While refilling it we have take good care.. we must make sure that there is no air in the syrenge while sucking the ink...

And make sure there is no traces of ink on the censor or the circuit of the cartidge

 

[thewisecrab]

i REMOVED THE TAPE AND EVERY THING ELSE OBSTRUCYING THE COPPER PLATE
STILL IN VAIN....

 

[Gigacore]

Do one thing..suck all the ink back from the cartidge...

clean the nozel in vericle sweeps using a smooth cotton cloth.. and refill again..

 

[thewisecrab]

cud u xplain how 2 suck the ink out
i have already cleaned the nozzles

i need the catridge in a few hours]

 

[Gigacore]

Insert the Syrenge deep into the cartridge via the hole..

make sure u have pushed the syrenge shaft to its tip and slow pull it back after u insert inside the cartridge.. do this for few times.. untill u feel its empty..

but also keep in mind that few cartridges cant be used for long time

 

[thewisecrab]

if i give it 4 refilling now
willl he do it and give?