My new Gainward GeForce 6200 doesn't work!

Discussion in 'Hardware Q&A' started by Ramstrong, Oct 15, 2006.

Thread Status:
Not open for further replies.
  1. Ramstrong

    Ramstrong New Member

    Joined:
    Jan 2, 2006
    Messages:
    10
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Bangalore
    Hi,

    I have an
    Intel Pentium D processor (805) 2.66 GHz;
    Foxconn MoBo 945 Chipset with in built Graphics display;
    Transend DDR 2 Jet Ram 1 GB (512 MB x 2 in dual channel);
    Zebronics 500 Watts SMPS;
    160 GB Seagate (7200) SATA Hard Disk;
    LiteOn 16X DVD-RW;
    Logitech Key Board & Mouse (cordless);
    17" LG CRT Monitor;
    Logitech Speakers 2.1

    Bought a new Gainward GeForce 6200 Turbocabhe with 128 MB DDR2 Memory couple of days back. Connected the same in the PCI-e slot. There is no output from the card to the monitor. Tried to install the nVidia display drivers from the CD but in vain. Tested the same card in another PC of similar configuration & it works fine. What could be the possible reason? How can I make it work on my PC? Should I return the card & get a new one? Kindly suggest!

    Thanks,

    Ramstrong.
     
  2. deathvirus_me

    deathvirus_me New Member

    Joined:
    May 15, 2005
    Messages:
    1,838
    Likes Received:
    4
    Trophy Points:
    0
    Location:
    Kolkata, India
    Did u change the "INIT Display First" to PCIe ??? It might be stuck to "Onboard" even after u plug in the card ....
     
Thread Status:
Not open for further replies.

Share This Page