Motherboard or graphic card???

[madmax_tt]

i have PI845GLM-P and nVIDIA AGP GeForce FX 5200 128MB graphic card. when i insert the card in agp slot, the fan start spinning but didnt gve output to the monitor. and when i connect the monitor cable to onboard graphic, my windows XP pro didnt show any "NEW HARDWARE FOUND" either. but the card work fine in 2 of my friends system. motherbaord is brand new. and i have 350W of smps. plz help me.........

 

[wizrulz]

Post ur full system config

 

[nishant_nms]

first uninstall the driver of ur onboard video then go to BIOS and disable onboard graphics and set AGP as the default graphics and u r done

 

[Lucky_star]

first uninstall the driver of ur onboard video then go to BIOS and disable onboard graphics and set AGP as the default graphics and u r done

Yah, that's the problem

 

[topgear]

1st check whether Ur mobo supports agp card coz some 845 motherboards
have some kind of warning labled on their agp slot not to use a graphics
card. If Ur mobo has nothing like that then follow these steps:

Uninstall the onboard graphics driver

POWER DOWN THE COMPUTER

1.Remove the AGP card & clean the AGP slot

2.Insert the agp card into the slot

3.Clear your mobos CMOS settings(ie bios settings) by jumper

>-<))))) See Ur mobos manual for Step No.3 & 4 ((((((>-<

4.Sit the jumper caps in the right place

5.Now start Ur Comp, Now it should boot & give U display

I have a Mercury PI845GLM-AGP board with 5200 Gfx card(AGP)
When i insert this Gfx card it gave me the same prob & I solved it
by the above steps.

 

[madmax_tt]

the manual shows that it support AGP card. i cleared the bios, disabled onbaord graphic and even clean the AGP slot. still i cannot get any display. i insert my friends ATI graphc crd ( i dnt know tha model), and that one also dnt gve any display

 

[topgear]

Then Ur mobo has some problem

 

[larsan]

try a higher (400 or 500w) power supply from any of ur friends

 

[s_aerin]

are u connecting ur monitor to the onboard port or to that of the card??

 

[madmax_tt]

i connect to onboard, it give display.......connect to graphic card, it dont give display........

 

[dOm1naTOr]

First set the " unit display first" in bios to AGP from PCI. Then try again.

 

[madmax_tt]

there is no AGP on "UNIT DISPLAY SYSTEM". Only PCI and ONBOARD. When i select PCI it give output to onboard not on the card