Enabling 2x transfer rate in my System board

Discussion in 'QnA (read only)' started by abs_shayz, Oct 8, 2004.

Thread Status:
Not open for further replies.
  1. abs_shayz

    abs_shayz New Member

    Joined:
    Oct 8, 2004
    Messages:
    3
    Likes Received:
    0
    Trophy Points:
    0
    Hi,
    I've a very interseting problem. Actually I don't know much about graphics card, its transfer tates, system baord, blah blah etc. Recently I'd installed Powerstrip to overclock my GC as described in Digit. From there I'd understood that my GC can support upto 2x, but now it's transfer rate is only 1x, while my MB supports upto 4x. I've a PIII 1.0 GHz, Zida's A815EU Intel Chipset board, 256 MB SDRAM, SiS 300/305 32MB GC, with Win XP Pro Ser.Pack 2 installed. Can anybody help me to correct this problem so that I can fully utilise my Graphics card.
    Thanx
     
  2. freshseasons

    freshseasons King of my own Castle

    Joined:
    May 7, 2004
    Messages:
    1,407
    Likes Received:
    0
    Trophy Points:
    36
    Location:
    EVERYWHERE
    Go to the motherboard Bios and Select the setting regarding AGP transfer rate...Select 4X from there and you are done... :p
     
Thread Status:
Not open for further replies.

Share This Page