1. Hey Guest Did you know you can win an Honor 10 phone worth ₹33,000 and an additional ₹70,000 in paytm vouchers, just by replying to some threads and taking part in the discussions happening in the Honor Hub?

    What are you waiting for? Start commenting and start winning! Remember to read the instructions posted here.

    Dismiss Notice

Bootup problem!!!!! plz HELP!!!

Discussion in 'Software Q&A' started by KKK, Feb 6, 2006.

Thread Status:
Not open for further replies.
  1. KKK

    KKK New Member

    Joined:
    Jun 11, 2005
    Messages:
    26
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Kharagpur
    :(
    i assembled a new system with the following
    athlon 64 3200+
    ASUS A8N-E mobo
    XFX GeForce 6600GT 256MB PCIe
    2x160GB Seagate Barracuda 7200.9 SATA 1 HDDs
    2x512MB Transcend Jet RAM modules (2.5,3,3)
    VIP 400W PSU

    my problem is that the even after checking and rechecking the connections....the PC does not boot up...it starts but there is no startup beep!!!
    also if i try to switch it off by pressing the Power Button for four seconds...only the Power LED goes off and the rest of the system is on...and thats where i loose control of the system because the only way then to switch off the system is to cut off mains power!!
    PLZ HELP!!!! :(
     
  2. senthilrek

    senthilrek New Member

    Joined:
    Oct 23, 2004
    Messages:
    62
    Likes Received:
    0
    Trophy Points:
    0
    Location:
    Chennai
    I think there should some problem with the Boards Front Panel. If its a new one ask your your vendor to show you the display. Thats the simple way i think.
     
  3. hermit

    hermit New Member

    Joined:
    Dec 28, 2005
    Messages:
    151
    Likes Received:
    2
    Trophy Points:
    0
    Plz check the smps connection s once again
     
  4. ::cyborg::

    ::cyborg:: Member

    Joined:
    Oct 5, 2005
    Messages:
    438
    Likes Received:
    8
    Trophy Points:
    18
    Location:
    NEW DELHI
    yes i think u by mistake inserted the wong led wire in the jumper recheck the jumper and also consult ur manual it is only the think which can help u out

    and were u wearing the anti static wrist wrap while assembling??????????
     
Thread Status:
Not open for further replies.

Share This Page